First things first in getting Molly ready for the wedding is to give her a face lift. She's getting on a bit and everything is starting to slip as it happens to the best of us. We decided to respray her and make any required repairs along the way.
Here she is looking a bit of a sorry state after her rear door had fallen off. This happened earlier in the year but other projects meant the repair was postponed. In the picture you can see I have started the long and arduous task of rubbing her down.
Now, Our Molly doesn't have an awful lot of steel in her compared to other vans of her size but what steel there is is subject to the same fate; rust. We'd done a bit of welding to her before including repairing the bulkhead, a small section of chassis and the NS inner wheel arch. But I also knew there was some lurking behind her front panel so I removed it to make the repairs.
Here is a section I removed and next to it is the new one I made to replace it. At the bottom is another replacement although I've not yet made the square hole in the pic.
The next sequence of photo's show the section being installed. The top of the panels either side of the radiator were also rotton and needed replacing as were the forward part of the front wheel arches. All the metal is good nick was ground back, treated and then primed. I'll paint this all and waxoil what needs waxoiling in the near future.
Showing posts with label AC Delco Bedford CA. Show all posts
Showing posts with label AC Delco Bedford CA. Show all posts
Monday, 2 September 2013
Tuesday, 15 March 2011
An Irritating Case Of An Incontinent Fuel Pump
After we’d fitted the rebuild kit to the AC Delco fuel pump all was fine for a while. Then after refitting the fuel line one day it started pissing out with fuel when the engine was running. The original fuel line is copper and it looked pretty rough so I ordered a new nut and olive and decided to remake the line. While the pump was off I noticed it looked as though it had been cross threaded. I took it to a friend of mine to helicoil but he returned the same afternoon saying that it was fine and probably came out the factory looking like that. The parts arrived in the mean time but I had been sent the incorrect size olive. I refitted it anyway and sure enough it leaked again so I decided to replace the pump instead.
These pumps are not unique to the Bedford range so I found one on eBay listed as for a MG or Humber, the advert couldn’t be sure. The mounting flange was different but I was hoping I could splice the two together. When it arrived we checked it over and the top half of the new pump fitted the bottom half of our old pump perfectly.
I stopped into the Landrover garage again so see if he had the correct olive and he produced a length of hose the same diameter and the ID of the nut and the corresponding olive. I think he said it was from a series Landrover. Anyway, it meant that we could do away with the copper line and run a flexible plastic one much more suited to absorbing the vibrations of an old vehicle like ours. Success.
The different flanges. The new upper has been fitted to our old pump lower (left)
Subscribe to:
Posts (Atom)